Mindman Solenoid Valve Model MVSC-300-4E2C, specify voltage

 

Function:

        This is a 5 ported 4 Way Directional Control Valve used to move cylinders or actuators.  Supply pressure must be supplied to the center port on the side of the valve with the 3 ports.  The outlet ports on the opposite side are connected to each side of a cylinder or actuator.  In the center position, both sides of the cylinder or actuator are blocked so the cylinder is stopped from moving.  When voltage is applied to the solenoid end of the valve, the valve spool will shift causing air to go to the opposite side of the cylinder while exhausting the side that was pressurized.  This causes the cylinder to shift (or extend).  When the voltage is removed, a spring will return the spool to the center position and both ports will be blocked.  When Voltage is applied to the opposite Solenoid, the cylinder will shift in the opposite direction.  Blocked Center valves are used to stop motion on the cylinder or actuator in case of a power failure.  Mufflers may be added to the exhaust ports to quiet the air exhausting.  Adjustable Exhaust restrictors may be used to in the exhaust ports to control the speed of the cylinder.  If flow controls are used, they should always be placed in the lines between the cylinder and the outlet ports and control the air flow as it exhausts from the cylinder.

MVSC-300 CATALOG (PDF)

 

Specifications:

          Media- Air (Minimum 40 micron filtration)

          No of positions and Ports- 2 Position, 5 Ports

          Flow- Cv= 1.6, Equivalent Orifice Area= 30 mm², (75 cubic feet per minute at 80 PSI)

          Port Size- IN OUT=3/8 NPT, EXHAUST = 3/8 NPT

          Voltage range- plus or minus 10%

          Pressure Range- 24PSI min to 100 PSI Maximum

          Wire Insulation- Class F

          Weight= 1.4 lbs